advice

[solwiso]

I have a Freewheeler Trike HD. I install a new batt and now my rear left light dont work, plus when i hit the break the stop light will not work. Plus I have LED lights and they stay on in red color, it will not change color. What can it be the problem

 

[Jack Klarich]

Luis, Welcome to Trike Talk

What kind of LED lights do you have?

It sounds as if your brake light switch has stopped working, you can verify this by doing a scan of your computer, follow this link and write down the codes, I bet your rear brake light is the culprit

https://www.appletonhd.com/harley-davidson-trouble-codes/

 

[Jack Klarich]

You are in Jacksonville Florida, I am also. If you cannot figure it out I can take a look at it for you

 

[solwiso]

Assistance

So you do live in Jax Fl.. Good

The LED I have on the bike is Shock&Awe2.0

 

[Jack Klarich]

So you do live in Jax Fl.. Good

The LED I have on the bike is Shock&Awe2.0

Yes I do, Mandarin off SanJose and 295

See my post #2, scan your trike and post what you find

If you have trouble with the scan you can stop by my house and I will show you how to do it

3566 Hampton Glen Place, Jax Fl 32257

 

[solwiso]

Assistance

Alright, let me try the scan.... will be back in a few

 

[Jack Klarich]

Have a look here at the instructions for your lights, it sounds like you may have to reset them

Scroll down and read the operating instructions

https://cdn.shopify.com/s/files/1/0...Engine_Starter_Kit_a.pdf?12353914245219476863

 

[Jack Klarich]

it sounds to me your system is in sleep mode from the disconnect and re connect of your new battery, see below on the instruction page and try a reset

Sleep mode:-To enter sleep mode, press and hold the button for approximately 3-5 seconds. The lights will flash indicating sleep mode.-Once in sleep mode, the motorcycle cannot not be found through Bluetooth; this minimizes any possible battery drain. The lightscannot be controlled through the APP in sleep mode.-A simple short press of the button will take the system out of sleep mode and be discoverable again.Factory reset: -Press and hold button for 10+ seconds, the lights will flash. -This forgets all Bluetooth settings, and system would need to be rediscovered through the APP.

 

[solwiso]

Assistance

ok,, i did it. what I read is as follow:

BCM: 62123 / 62124 / 62151 / 62271 Pn: 69994-128

SPDO: 61210 Pn 70900379

 

[solwiso]

Assistance

Sorry to ask,, but you mention to press down the button. My question is,, what button

 

[Jack Klarich]

ok,, i did it. what I read is as follow:

BCM: 62123 / 62124 / 62151 / 62271 Pn: 69994-128

SPDO: 61210 Pn 70900379

What year is your Freewheeler, are you sure about those codes, the 6 are B, the part number is the BCM that is showing the codes

Follow that same link and clear the codes, start your trike after you reset your light kit, see post #8

The last code is a low BCM volt code, will your trike start?

 

[Jack Klarich]

Sorry to ask,, but you mention to press down the button. My question is,, what button

The trigger switch on the top side of the Left Hand side switch pak, # 11

 

[solwiso]

Assistance

Is a Freewheeler HD, 2016.

 

[solwiso]

Assistance

PLus the batt is only three days old.. I should not have a low batt

 

[Jack Klarich]

Is a Freewheeler HD, 2016.

OK, did your trike come with this light kit? Do you have an app on your phone to control them?

 

[solwiso]

Assistance

The light kit was installed over a year and half.

 

[solwiso]

Assistance

Yes,, it has an APP. Is control by phone, plus it has a switch under the seat which it can be control as well.

 

[Jack Klarich]

PLus the batt is only three days old.. I should not have a low batt

The last code is reading the BCM volts as low, with out a meter across the top of the battery we do not know how low it is

 

[Jack Klarich]

Yes,, it has an APP. Is control by phone, plus it has a switch under the seat which it can be control as well.

Turn the switch off and start your bike, do your brake and turn signals work?

 

[Jack Klarich]

The light kit was installed over a year and half.

Yes,, it has an APP. Is control by phone, plus it has a switch under the seat which it can be control as well.

Try to reset the app